Skip to main content

DOF's Reverse Milling

 




CRAFT 5X mills a pre-milled abutment by “Reverse Milling” method.
Since “Reverse Milling” is a 5-axis milling, all problems of a 4-axis milling have been solved. It is possible to mill not only occlusal areas, but also undercut areas.
This is why you want CRAFT 5X!😎


Labels:

Comments

Post a Comment

Popular posts from this blog

ScanApp's V. A. Set-up and exocad's virtual articulator

Set the occlusal plane easily with DOF's ScanApp.
Post a Comment
Read more

ScanApp v2.5.560 has released!

ScanApp v2.5.560 has released. DOF is constantly working to improve ScanApp and check out the latest ScanApp updates here https://doflab.com/scanapp/
Post a Comment
Read more

DOF FREEDOM scanner - Calibration

This video will guide you with the calibration process of the scanner. Calibration requires a calibration plate and two scan plates. Always keep the scan plate clean and do the calibration at least once every two weeks. If you have any inquiries about calibration, please contact us by email below. Support@doflab.com Visit us  http://doflab.com
Post a Comment
Read more